MX-M503N MX-PNX1 5 – 1
MX-M503N
Service Manual
[5] MX-PNX1
1. Unpacking
A. Removal of the punch unit
B. Removal of the fixing tape
1)
Remove the fixing tape.
C. Check the packed items
1)
Check that all the items are included in the package.
* Do not use the punch position label which is one of the packed
parts, but use one packed in the package of the finisher (MX-
FNX9).
2. Installation
*
When the punch unit is installed together with installation of
the MX-FNX9 (inner finisher), first install the inner finisher,
and then install the punch unit.
<Note before installation>
* Before starting installation, check to insure that the data lamp on
the operation panel does not light up or blink.
* Do not install the punch unit first because doing so would cause
interference between the inner finisher slide rail and the punch
unit drawer connector (possibly resulting in failure) when you
attempt to install the inner finisher.
A. Turn off the power of the main unit
1)
Turn OFF the power switch on the operation panel.
2)
Open the front cabinet.
Turn OFF the power switch in the front cabinet of the main unit.
3)
Disconnect the power plug of the main unit from the power out-
let.
No.
Packed part names
Quantity
1
Punch position label (For scanner)
1
2
Punch position label (For RSPF/DSPF)
1
1
2
OFF
