SHARP
REPAIR HINTS
57
GENERAL / MISC
ALL
Slow operation and/or machine
performance (including slow browsing
experience of the MFP webpage).
Backup and clear the job log data (especially when the
job log exceeds 60,000 entries).
Also execute Job Log & HDD optimisation where
available
SRDM does not show status of copier
SRDM ( Sharp Remote Device Manager )gets data from
the copier using SNMP . If this is disabled by using SIM
55-3 Sw. 9 , bit 5 , then SRDM cannot monitor the
status of the copier .
Please note that the copier needs to be power cycled at
the mains for changes to the soft switch to take effect.
What is the function of the Digital Line
Network checkbox?
In past examples, when connecting the FAX machine to
an IP telephone network, if the outgoing signal level
was high, communication trouble frequently occurred.
Because of the above, there were many cases where
technicians had to adjust the outgoing signal level via
FAX Soft SW when this occurred.
For this reason, the above setting has been added to
avoid communication trouble when connected to an IP
telephone network. This setting can be changed within
the MFP web page by the administrator.
System Settings –> Image Send Settings –> Fax Settings
–> Default Settings.
When Digital Line Network is enabled (ticked), the
signal outgoing level of FAX is set to -15dBm
When using the LCD panel to change
System Settings, only Top Page and
System Settings are listed within the
menu.
Go to the service webpage
http://IP_Address_of_MFP/service_login.html.
Default Username & Password= "service".
Select "Administration Settings" and execute "All" to
display all the settings.
Machine unable to wake up from
Sleep Mode
Check/change the following soft switch setting:-
Sim 66-1 (Fax switch) SW92, Set bit 7 = 1.
Please see administrator for
assistance (code pc) message on the
display, only after replacing the SCU
PWB from spare parts.
Check and ensure CN16 jumper is transferred from the
original to new SCU PWB.
UI becomes unresponsive when
selecting any icon from the HOME
screen (machine appears to hang)
Press and hold down the HOME key for approx. 5-10
seconds. If the counter window appears after a
period of time, the touch key operating setting
maybe changed.
Via the MFP webpage, restore system settings or
check the following settings:-
Time for Accepting Key Entry: 0.0sec
Time for Accepting Key Entry of Long Touch: 0.5sec
Double Tap Interval Setting: 0.5sec
USB Card reader not recognised
Change Sim 55-03, SW No.6 DATA No.8 from 0 to 1
Summary of Contents for MX-5111N
Page 52: ...SENSOR LOCATION SHARP 52 Sensor Location ...
Page 68: ...NOTES SHARP 68 ...
