SHARP
COIN VEND INTERFACE
19
All MX series machines have a coin vend interface located on the PCU Main PWB. The vending device
activates various signals to indicate paper sizes and operation.
Connector Manufacture:
JST (
www.jst.com
)
Connector Type
PND series
Connector Part Code (Wire Side)
PNDP-16V-Z
Before connecting a third party auditor, the device should confirm to the following:-
1.
The auditor interface should be optically isolated from the copier.
2.
The device should be Power Supply Unit independent.
3.
The device power supply unit should be a plug top adapter, not internal.
4.
The plug top adapter should have a reinforced insulation barrier.
5.
The audit device
MUST
comply and display the relevant safety approval mark (C-Tick, CE
or equivalent).
To enable coin vend function, test simulation 26 –03 should be set as required:-
Coin Vendor Mode
Diagnostic
Setting
The specified
quantity is
completed.
Remainder of money
is left
Insufficient money during copy job
The specified
quantity is
completed.
No money
remaining
Black/Colour
(No money
remaining)
Colour
(Remainder of
money left)
Condition 1
Condition 2
Condition 3
Condition 4
MODE 1
Operation 1
Operation 2
Operation 2
Operation 1
MODE 2
Operation 1
Operation 1
Operation 2
Operation 1
MODE 3
Operation 1
Operation 3
Operation 2
Operation 3
OPERATION 1 Wait for auto clear setting time
(Default 60sec – can be changed by the system setting)
OPERATION 2 Auto clear is not made.
OPERATION 3 Setting is immediately cleared.
Cont’d
Summary of Contents for MX-5111N
Page 52: ...SENSOR LOCATION SHARP 52 Sensor Location ...
Page 68: ...NOTES SHARP 68 ...