1 – 5
FO-CC500A
FO-K01A
[4] Installation
1. Site selection
Take the following points into consideration when selecting a site for this
model.
ENVIRONMENT
•
The machine must be installed on a level surface.
•
Keep the machine away from air conditioners, heaters, direct sun-
light, and dust.
•
Provide easy access to the front, back, and sides of the machine. In
particular, keep the area in front of the machine clear, or the original
document may jam as it comes out after scanning.
•
The temperature should be between 5 - 35
°
C.
•
The humidity should be between 25% and 85% (without conden-
sation).
ELECTRICITY
AC 230 - 240V, 50Hz, grounded(3-prong) AC outlet is required.
Caution!
•
Connection to a power source other than that specified will cause
damage to the equipment and is not covered under the warranty.
•
If your area experiences a high incidence of lightning or power surges,
we recommend that you install a surge protector for the power and
telephone lines. Surge protectors can be purchased at most telephone
specialty stores.
If the machine is moved from a cold to a warm place...
Condensation may form on the reading glass if machine is moved from
a cold to a warm place, this will prevent proper scanning of documents
for transmission. Turn on the power and wait approximately 2 hours be-
fore using machine.
TELEPHONE JACK
A standard line cord must be located near the machine. This is the tel-
ephone jack commonly used in most homes and offices.
•
Plugging the fax machine into a jack which is not line cord may result
in damage to the machine or your telephone system. If you do not
know what kind of jack you have, or need to have one installed, con-
tact the telephone company.
2. Loading the imaging film (FO-6CR)
Your fax uses a roll of imaging film to create printed text and images.
The print head in the fax applies heat to the imaging film to transfer ink
to the paper. Follow the steps below to load or replace the film.
•
The initial starter roll of imaging film included with your fax can print
about 30 A4-size pages.
•
When replacing the film, use a roll of Sharp FO-6CR imaging film.
One roll can print about 150 A4-size pages.
If you are loading the imaging film for the first time,
go to Step 4.
1
2
1
2
Remove the used film and empty spool.
3
Remove the two green gears from the spools.
DO NOT DISCARD THE TWO GREEN GEARS!
1
Remove the paper from the paper tray and open the operation panel
(press ).
1 slot
2 slots
4
Remove the new roll of imaging film from its packaging.
• Cut the band that holds rolls together.
5
Insert the green gears.
Make sure the gears fit into the slots in the ends of the rolls.
Summary of Contents for FO-CC500
