Sharp FO-CC500, Service Manual

Page: 22 / 162

FO-CC500A
FO-K01A
2 – 9
5.3.9 Headset test mode
1
After going into the mode, cordless handset will check the jack of headset.
• If headset are put in the jack, “DETECT HEADSET” will be displayed.
2
By inputting off key, it goes to stand-by state of Production mode.
OFF
1 1
1 1
1
Mode No.
2 2
2 2
2
End of mode
Input key Input key
0 9
5.3.10 Bit rate test mode
1
After going into the mode, cordless handset will test the Bit Rate.
2
By inputting off key, it goes to stand-by state of Production mode.
OFF
1 1 1 1 1
Mode No.
2 2 2 2 2
End of mode
Input key Input key
1 0
5.3.11 INTERCOM test mode between cordless handsets (FO-K01 ONLY)
1
After going into the mode, please enter the system ID. (1digit, 0 ~ 9)
NOTE: You have to enter the same number for both partner cordless handsets do this test.
If this test is done at more than 2 places in the communication area, please use the different System ID between each place.
This rule is necessary to avoid the jamming.
2
Please enter the cordless handsets number.
NOTE: You have to set the different number for the partner cordless handsets.
3
After above, cordless handset returns to the stand-by mode.
4
You can call the partner cordless handset by pressing IN its cordless handsets number.
The operation after this is equal to the INTERCOM communication specification.
CAUTION: After this test, before packing, you have to do “MEMORY CLEAR”.
OFF
1 1
1 1 1
Mode No.
2 2
2 2 2
System ID
3 3
3 3 3
Cordless handsets No.
4 4
4 4 4
End of mode
Input key Input key Input key Input key
2 0 0 ~ 9 1 ~ 4