CD-DV999W
E-66
ENGLISH
Advanced Features
4
CD-DV999W (
Z
)
TINSZA017AWZZ
H
Digital connection to a Dolby digital, DTS/MPEG
audio processor or MD recorder
You can record sound on a digital audio recorder by connecting to the digital
audio output socket using an optical digital cable.
When connecting a digital audio recorder to the digital audio output socket,
set the “
DIGITAL/MPEG” to “D-PCM/PCM” (see page 24).
BIT STREAM
For 5.1 channel Dolby Digital/DTS surround processors, etc.
D-PCM/PCM
For 2 channel digital input amplifiers, etc.
Note:
Some discs are copy protected and digital recording is not possible (including
DTS signals).
Troubleshooting chart
Many potential problems can be resolved by the owner without calling a service
technician.
If something is wrong with this product, check the following before calling your
authorised SHARP dealer or service centre.
H
General
Symptom
●
The clock is not set to the
correct time.
●
When a button is pressed,
the unit does not respond.
●
No sound is heard.
Possible cause
●
Did a power failure occur?
Reset the clock. (Refer to page 16.)
●
Set this unit to the power stand-by mode
and then turn it back on.
●
If the unit still malfunctions, reset it.
(Refer to page 68.)
●
Is the volume level set to “0”?
●
Are the headphones connected?
●
Are the speaker wires disconnected?
●
Is the Karaoke mode set to “L-CH”, “R-
CH” or “V-CANCEL”?
H
Remote control
Symptom
●
The remote control does not
operate.
Possible cause
●
Is the AC power lead of the unit plugged
in?
●
Is the battery polarity correct?
●
Are the batteries dead?
●
Is the distance or angle incorrect?
●
Does the remote control sensor receive
strong light?
To the digital
input socket
Optical digital lead
(not supplied)
Dolby digital, DTS/MPEG
audio processor or
MD recorder
An optical digital cable is not supplied.
Purchase an optional optical digital cable.
References
*DV999W_EP61-66
04.3.4, 17:50
66
