Sharp AR-6020DV Service Manual Download Page 51

Page: 51 / 151

AR-6020V SIMULATIONS 6-12

Cancel of stop at developer life over

When this simulation is executed, the current set code number is displayed. Enter the desired code number and
press the [START] key to set the code number. The machine goes into the sub code input state.

Cancel of stop at drum life over

When this simulation is executed, the current set code number is displayed. Enter the desired code number and
press the [START] key to set the code number.

Memory capacity check

When this simulation is executed, the current memory capacity is displayed on the number of copies display.

Side void amount setting

Used to set the side void amount on the both sides.
Enter a set value with the Numeric keys and press the [START] key, and the entered value will be saved and the
machine will go into the sub code input standby mode.
The setting range is 0 - 10. When the set value is increased by 1, the void amount is increased by 0.5mm. The
default is 5 (= 2.5mm).
To select the setting mode, press the [AUTO/TEXT/PHOTO] key. The set value of the selected mode is displayed
on the copy quantity display. At that time, the set value is also saved.

When the setting value is increased by 1, time is increased by 0.5ms.

Copy temporary stop function setting

When any key is pressed, it is displayed on the display section. When the [START] key is pressed, the set code
data is acquired and stored to the setting variable of sort/group copy temporary stop function and to the EEPROM.
The machine goes into the sub code input standby mode.

When the [INTERRUPT] key is pressed at that time, the machine goes into the sub code input standby mode
without rewriting the data. When the [CA] key is pressed, the simulation mode is terminated without rewriting the
data.
* When this is set to "Stop," temporary stop is made for every 250 copies in one copy job.

Life correction ON/OFF setting

Setting is made whether the image correction is made according to developer consumption degree (life progress)
or not.
When this simulation is executed, the current code number is displayed on the number of copies display.
(1=ON [Correction is performed.], 0=OFF [Correction is not performed.])
Enter the code number and press [START] key, and the setting is settled and written into the EEPROM and the
machine goes into the sub code input standby mode.
Switching can be made with [AUTO/TEXT/PHOTO] key, and the set value of the selected mode is displayed on the
number of copies display..
The setting entered at that time is written into the EEPROM.

Used to set the operating for toner end

This simulation used to set the operating conditions for toner end.
When this simulation is performed, the current code number is displayed.
Enter a code number and press [START] key to save the setting.

<<Operations at toner end >>

Main
code

Sub

code

Contents

Details of operation

Code number

Setting

0
1

Stop at developer life over
Cancel of stop at developer life over * Default

Code number

Setting