Sharp AL-1043, Service Manual

Page: 39 / 126

AL-1551 DISASSEMBLY AND ASSEMBLY 8-2
2) Set the charger cleaner to the transfer unit, and move it reciprocally a
few times in the direction of the arrow shown in the figure below.
E. Charger wire replacement
1) Remove the TC cover and remove the screw.
2) Remove the spring and remove the charger wire.
3) Install a new charger wire by reversing the procedures (1) and (2).
At that time, be careful of the following items.
•The rest of the charger wire must be within 1.5mm. Refer to Fig.1
•The spring hook section (charger wire winding section) must be in the
range of the projection section.
•Be careful not to twist the charger wire.
2. Operation panel section
A. List
B. Disassembly procedure
1) Remove the screws (4 pcs.), the harness, and the operation panel
unit.
2) Remove the screws (3 pcs.) and the PWB holder.
3) Remove the screws (3 pcs.) and the operation PWB.
C. Assembly procedure
For assembly, reverse the disassembly procedure
1)
2)
3)
4)
1mm
1.5mm
Fig.1
1)
1)
2)
3)
Charger wire
Protrusion
No. Part name Ref.
1 Operation panel unit
2 Operation PWB
1)
2)
3)
1)
1)
4)
3)
1)
2)
3)
3)
Note that there are 13 pawls
& ! "#$%