Sharebot Next Generation XXL+
user's manual
Detach the printed part
When printing is complete, your Sharebot XXL+ positions the platen down and park the extruder. In this position you can easily extract the printing glass after removing
the clips to detach the printed object it from.
This operation is delicate and inevitable: to complete correctly the printing, it's necessary that the first layer adheres well and remains attached to the printing glass
for the entire duration of the process. If there was not a good grip, the mechanical stress and the pressure of the tip of the extruder on the model it would detach the
model itself, ruining irretrievably printing.
Detach the model asks a certain skill, a thin spatula or a knife with a wide blade. You need to wait a few minutes, as is necessary to cool the glass and the model
itself, which would otherwise deform due to the temperature of the printing surface. Cool down the printed part helps you to detach it.
Remember to pay maximum attention during the proceedings: please wear protective gloves to avoid injury due to the warm glass plate or knife.
Whether you use a spatula or knife, you have to try to put the tool below one side of the printed part, then with horizontal movements, without trying
to lift the printed part, you have to sink the blade to the opposite side. If you look at the printed part through the glass, you can also find the any discolored
areas of the model, sign that in that area there's already been a detachment from the glass and then thread at that point the tool. Usually the piece
jumps off without too much force and without having to get completely on the other side . If the model has legs or thin part, try to gently detach these
before, to detach the the wider part. In this way we avoid breaking the thin parts. In the case of models with a single wide base, start fro m one side, t ry i n g to p u t
t h e k n i fe d e e pe r a n d d e e p e r, with an oscillatory movement to advance the blade.
Sharebot srl
Nibionno Italy
All rights reserved
. No part of this manual
may be reproduced or transmitted in any form or by any means without prior permission
page 26