Sharebot Next Generation XXL+
user's manual
“Tune” menu
The item is displayed only while the machine is printing; the commands we find in are:
Info Screen
Check filament: ON/OFF
Change filament
Fan speed
Nozzle
Bed
Flow
Speed
The first voice is about the sensor that monitors the presence of the filament. When the sensor no longer detects the filament, the printer goes automatically into change
filament procedure (identical to that described afterwards); the buzzer sounds and the printer waits to receive the new filament just for 24 hours. By pressing the control
knob the buzzer will stop and the machine will be ready for the loading of the new filament. Clicking control knob another time will resume the printing.
You can disable the sensor of the filament: select the "prepare" menu and from "check filament” you can chose "ON" or "OFF"; at the start of each print the value is reset to
"ON". The same procedure is possible from “tune” menu.
The following voice is used to change the filament while printing: since the printer has the “check filament sensor” this item permits you to change filament when you
want, for instance if you want change color.
The procedure starts with the shift of the extruder in parking area, then the extruder motor expels the current filament and the internal buzzer is activated as soon as the
filament is unloaded. Press now the control knob to insert the new filament: the extruder motor will help you dragging the filament, while you insert it in contact with the
cogwheel of the stepper motor. When the flow of the new filament is ok, press the control knob again to resume printing.
The next item is the fan speed, adjustable from 0 to 255; with very low values the fan may not even start.
Sharebot srl
Nibionno Italy
All rights reserved
. No part of this manual
may be reproduced or transmitted in any form or by any means without prior permission
page 19