3 Using the system
│
25
When saving a measurement you can store optional additional
information (e.g. a comment).
In order to compare measurements, they should be taken in the
same conditions where possible. The following factors affect
comparability:
●
Environmental noise
● Selected filter limits
●
Recording time
3.4
Starting and ending a measurement
To start and end a measurement you must use either:
●
Activation key on
A 200
receiver
●
Sensor area on
TS 200
carrying rod
More detailed advice on which controls are best suited to which
microphone can be found in section 6.4 on page 74.
The easiest way to tell whether or not a measurement is being
taken is by looking at the main view. A measurement value is
displayed during a measurement (black figure).
3.5
Adjusting the hearing protection threshold and volume
A
CAUTION! Health hazard
Excessive noise can damage hearing and lead to irrevers
-
ible damage to health.
This risk applies to both sudden loud sound interference
and the volume being set too high.
●
Always adjust the hearing protection threshold and vol-
ume to the current situation.
●
Set the hearing protection threshold as low as possible.
●
Choose as low a volume as possible.
The hearing protection threshold and volume are set in the
Vol-
ume
menu.
