82
Operating Instructions – Electronic Motor DRC.-..-DAC
6
Startup with binary slave GLK30A in "Expert mode"
Startup
6.7.2
Assigning the slave address
DRC drive units with AS-Interface are assigned address 0 at the factory.
You have the following options for assigning the AS-Interface address of the DRC drive
unit with AS-Interface (address 1 - 31):
• Addresses are assigned automatically within a configured AS-Interface system when
replacing a DRC drive unit with AS-Interface.
The following requirements must be met:
– The new DRC drive unit with AS-Interface must have the address 0.
– If you replace several DRC drive units with AS-Interface, you must replace them
individually (one after the other).
• Manual address assignment via the plant master
The drive units must be connected to the AS-Interface cable one after the other.
Doing so prevents several DRC drive units with AS-Interface from having assigned
the same address.
• Manual address assignment using a hand-held AS-Interface programming device.
When connecting the DRC drive unit with AS-Interface to the AS-Interface cable,
observe the notes in chapter "Assigning the slave address using a hand-held
programming device (GLK30A)".
00
I
