Servend STH14, Technician'S Handbook

Page: 93 / 204

Part Number STH14 5/09 93
Flavor Magic Programming
To exit the program mode at any time hold the
program button for >3 seconds and the controller will
switch to the dispense mode. The program mode can
only be accessed by pressing the program button
during the first five seconds of initial power up.
PROGRAM DISPENSE TIME
1. The program mode is used to adjust the dispense
time. To access the Program Mode, disconnect
power to the control board, wait ten seconds and
reconnect power.
2. Press the program button one time on the control
board during the first five seconds after power is
applied.
3. The LED display will show “P r o”. To check the
current dispense time, press the corresponding
flavor button on the touchpad and the time will be
displayed on the LED (Example “1.0”). a. To
increase the time (+) by two-tenths second
increments press flavor button 1 (far left button).
b. To decrease the time (-) by two-tenths second
increments press flavor button 3 (far right button).
The default setting is one second.
Program
Button
LED
Display
STH14.book Page 93 Monday, May 4, 2009 1:48 PM