Sequoia LISST-HOLO, User Manual

Page: 53 / 73

LISST-
HOLO User’s Guide
53
Submit log for analysis
Clicking the Send Log button will send the deployment log to Sequoia for troubleshooting. The
LISST-HOLO must be connected to the internet and it must be rebooted after the Send Log button
has been clicked for the log to transfer.
Generate log file
The Generate Log file button creates a text file of the instrument log in the images folder of the
LISST-HOLO, which can be offloaded using FTP. It is useful for troubleshooting.
Check for updates
Clicking the Update button will prompt the LISST-HOLO to check for software updates and
automatically install them. It is necessary for the LISST-HOLO to be connected to the internet and
the unit must be rebooted before the changes will take effect.
Network parameters
Use Network parameters to change the IP address of the LISST-HOLO. Click Apply when you
have changed it, but make sure that it is correct. The changes will take effect immediately, so you
will need to enter the new IP address in your browser to continue working with the LISST-HOLO.
Delete all images
Click the Delete button to delete all files on the internal hard drive of the LISST-HOLO. You will be
asked to confirm. When you have confirmed the Tools page will refresh, and another 5 seconds
after this the LISST-HOLO will begin to delete the holograms. During the time the LISST-HOLO is
deleting holograms it WILL NOT RESPOND. Clicking any of the links will result in a time out and a
blank browser page. Deleting 1000’s of holograms can take 5-10 minutes. Upon completion, the
LISST-HOLO will become responsive again. There will be no indication from the LISST-HOLO that
it is responsive, but clicking on the Images page will show that no images are available.
The parameters described below should NOT be changed without first consulting Sequoia. They
are to be used for troubleshooting and problem resolution only.