Sequoia LISST-HOLO, User Manual

Page: 16 / 73

16 LISST-
HOLO User’s Guide
Look at the LISST-HOLO connector endcap. Disconnect the External Memory Module
if it is connected.
Undo the dummies and connect the 5-pin cable to the 5-pin bulkhead connector #1
(just below the serial number) and the yellow Ethernet cable to 8-pin bulkhead
connector #2 (just above the serial number).
Note that the External Memory Module and the Ethernet cable share the 8-pin
bulkhead connector.
The cables are now correctly connected to the LISST-HOLO.
It is necessary to have BOTH cables connected in order to power and communicate
with the LISST-HOLO. No power is supplied through the yellow Ethernet cable, only
communication.
Connect the yellow Ethernet cable to the wireless router.
DO NOT use the port to the far left.
Connect the router power cable to the router
Plug the router power supply into a 110-220VAC power source.
When the router completes its booting procedure it can be located as
LISST-Holo on a
wireless network. The password for connecting to the router is manyholograms (this
information is also located on the bottom of the router). Establish a Wi-Fi connection
between the router and your PC before you proceed.
If you do not have a Wi-Fi enabled PC, use the black Ethernet cable for connecting the
router to the Ethernet port on your PC.