www.blazecut.com
Page 53 of 93
ILP CLEAN AGENT MANUAL-ILPCAM1904
BlazeCut and the BlazeCut logo are the registered trademarks of BlazeCut
© 2019 BlazeCut, All rights reserved
S1. Cut the BlazeTube detection straight, maximum degree of chamfer is 5°
To cut the BlazeTube detection use special pliers ATP001 (on the left) or cutter (on the right) included in
the Tool charging kit KATC001
To remove the roughness and sharp edges on the ends of the BlazeTube detection use alignment tool ATA001.
Insert the tube all the way into the tool and slowly turn the tool around a few times. Eject the tube, there is
a straight edge with 20° degree at its end.
Procedure for de buring the end of the BlazeTube detection
Fasten the BlazeTube detection firmly so that it is slotted into the BlazeTube outlet and pushed all the way by
hand. After slotting always check if the BlazeTube is firmly fastened by gently pulling it. Do not open the ball
valve of the connector for BlazeTube detection yet.
Scheme of connecting the
BlazeTube detection to the
connector on the valve of
the cylinder (example: valve
10 on the left, valve 35 on
the right)
1. BlazeTube Detection
2. BlazeTube Detection
outlet connector CBTO006
S1. Slot the BlazeTube detection firmly into the connector all the way
S2. Pull the BlazeTube detection slightly and make sure that it is firmly fastened
1.
3.
2.