ST-200 aQua
Operator’s Manual
74
TROUBLESHOOTING
8. Troubleshooting
Introduction
To enhance trouble-free operation of the ST-200 aQua, it is imperative to
follow the maintenance schedule outlined under ST-200 aQua
maintenance.
When any error messages appear in the display, then refer to the list of
“typical error messages” to locate the problem area and proceed to the
appropriate section for troubleshooting instructions.
When performing troubleshooting procedures, put the analyzer in
MAINTAINANCE
mode.
After removing the electrodes, solutions pack or after troubleshooting or
performing maintenance, the operator must do reagent priming before
calibrating the analyzer. To do this, proceed to the following procedure.
Menu
↓
Diagnostics
↓
Flow
↓
Reagent priming
↓
Prime all
When reagent priming is completed, perform calibration by pressing
CALIBRATE Key.
Warning: Human body fluid specimens may be contaminated with HIV or
other pathogens.
Treat all specimens, collection devices and analyzer components that may
come in contact with specimens as biohazards.
If the appropriate troubleshooting procedures do not correct the observed
error, contact your ST-200 aQua distributors.
Summary of Contents for ST-200 aQua
