Sennheiser evolution D1, System Manual

Page: 22 / 60

20
Putting the products into operation
왘
Unscrew and remove the four screws located on the sides of the receiver
housings.
왘
Secure the rack mount “ears”
1
to the sides of the receivers using the pre-
viously removed recessed head screws.
Make sure that the angled ends of the rack mount “ears” point forward.
왘
Slide the receivers into the 19" rack.
왘
Secure the rack mount “ears”
1
to the rack using the recessed head
screws 8.
Connecting the receiver to a mixing console
The receiver‘s ¼" (6.3 mm) jack socket
0
and the XLR-3 socket
A
are con-
nected in parallel, allowing you to simultaneously connect two devices (e.g.
amplifier, mixing console) to the receiver.
왘
Use a suitable cable to connect the mixing console to the ¼" (6.3 mm) jack
socket
0
or the XLR-3 socket
A
.
Connecting receivers in a network
You can connect several receivers in a network using a router or a switch. This
allows you to e.g. control, monitor and update all receivers and transmitters
of a multi-channel system via a mobile device or a computer.
“WSR” app Together with the “Wireless System Remote” (WSR) app, you can use one or
several mobile devices to remotely configure all receivers and transmitters of
a multi-channel system, to monitor their operation and to update the firm-
ware of the devices (for details, see page 38).
For this, your require a dual-band WiFi router, a sufficient number of network
cables and at least one mobile device (tablet or smartphone).
“Sennheiser D1 SL Updater” software You can use the “Sennheiser D1 SL Updater” software to update the device
firmware (for details, see page 39).
For this, you require any router or a switch, a sufficient number of network
cables and a computer running Windows 7 or higher.
To connect several receivers in a network using a router or a switch:
6.3 mm XLR
0
A
Updating the firmware without a network
If you do not have a router or a switch and only want to update the
firmware:
왘
Assign the computer a static IP address.
왘
Assign the receiver a static IP address ( Network Settings – Mode –
Fixed IP ) and then restart the receiver.
왘
Connect the receivers directly to the computer one after the other
and update their firmware.