12
TOOL OPERATION
LOADING THE TOOL:
Open magazine via rear latch. Insert strip of staples.
• Use only genuine SENCO fasteners (see Fastener Specifications).
• Do not load with workpiece contact (safety element) or trigger
depressed.
Close magazine.
UNLOADING THE TOOL:
Open magazine via rear latch.
Remove remaining staples.
It is normal for 4-7 staples to remain in magazine.
Tool Operation
Read section titled “Safety Warnings,” before using tool.
For best results, charge new battery before using. (see “To Charge Battery” on page 17).
Indicator LED ON
The tool should be switched off when not in use. Hold down either side of the selector
switch for 1 second to turn the tool off. If left on, the tool will automatically turn off
after 34 minutes.
All Fusion tools are equipped with selective-actuation triggering. This allows the user to choose between the
following modes of operation:
Indicator LED
ON-Flashing
Contact Actuation
Pressing the side of the selector switch toward the
TTT
symbol (as shown) for 0.5
sec. will turn the tool on in contact-actuation mode. This is indicated by the flashing
green LED of the selector switch.