15
www.selwoodproducts.com
Step 3: Swing Side Wall Assembly
A:
Loosely attach (1792) Lower Side and (2448) SW Floor with 4 (H2) 1/4 x 2” Hex Bolts (with lock washer, flat
washer and t-nut) per board; and (2445) Side Top using 2 (H2) 1/4 x 2” Hex Bolts (with lock washer, flat washer
and t-nut) to 2 (2469) Posts as shown in fig. 3.1. Notice the hole locations in (2448) SW Floor and (2445) Side
Top must be 9” from the (2469) Post shown in fig. 3.1.
Note: Pre-drill all holes using a 1/8” drill bit before installing the Lag Screws.
B:
Make sure assembly is square and then loosely attach (0369) Lower Diagonal to (1792) Lower Side on the
one side shown in fig. 3.1, with 1 (H2) 1/4 x 2” Hex Bolt (with lock washer, flat washer and t-nut), notice this is the
opposite side from Step 2. Fasten (0369) Lower Diagonal to (2469) Post using 1 (LS3) 1/4 x 3” Lag Screws (with
flat washer). (fig. 3.1)
C:
Tighten all bolts.
D:
Fasten (2445) Side Top to both (2469) Posts using 2 (S2) #8 x 1-1/2” Wood Screws. (fig. 3.1)
Wood Parts
Hardware
Fig. 3.1
1/4” Flat
Washer
1/4”
T-Nut
1/4” Lock
Washer
2 x
Post 2 x 4 x 82”
1 x
Side Top 1 x 4 x 51-1/2”
1 x
SW Floor 1 x 6 x 26-7/8”
1 x
Lower Side 1 x 5 x 62-3/8”
1 x
Lower Diagonal 2 x 3 x 37”
2469
11 x
1/4 x 2” Hex Bolt (1/4” lock washer, 1/4” flat washer, 1/4” t-nut)
1 x
1/4 x 3” Lag Screw (1/4” flat washer)
2 x
#8 x 1-1/2” Wood Screw
H2
1792
2448
2445
H2
Notice the hole
locations
2445
1792
0369
LS3
S2
LS3
1/4” Flat
Washer
S2
H2
S2
9”
H2
0369
2469
9”
2448
