52
commeo commissioning/setting by radio
Note for settings under point 5.2.: The drive must be selected for these settings with a
transmitter in SELECT mode (status LED slowly flashes orange). After the setting has been
configured, the drive is still selected (see point 5.).
5.2.4. Programming/deleting transmitters
To programme or delete a transmitter, select the required channel and press the PROG but-
ton for 1 second. The status LED lights up green to indicate that the transmitter has been pro-
grammed. If the status LED lights up red, this indicates that the transmitter has been deleted.
Status LED transmitter = green transmitter is programmed
Status LED transmitter = red transmitter has been deleted
1 s
5.2.5. Deleting the transmitter table in the receiver
To delete the transmitter table in the receiver, press the PROG button on the transmitter for
6 seconds. All transmitters that have been programmed in the receiver are deleted. The
receiver is deleted from the transmitter.
6 s
Note: This triggers an error message if there are any more programmed transmit-
ters!
If this receiver moves in operating mode over a transmitter which is still pro-
grammed, the transmitter will no longer receive a response and will acknowledge
this with an error message.
5.2.6. Resetting the receiver to the factory settings
To reset a receiver to the factory settings, press the PROG button on the transmitter for
9 seconds. All settings are reset to the factory settings. Transmitters and end positions are
now no longer stored in the drive. The receiver is deleted from the transmitter.
9 s
Note: This triggers an error message if there are any more programmed transmit-
ters!
If this receiver moves in operating mode over a transmitter which is still pro-
grammed, the transmitter will no longer receive a response and will acknowledge
this with an error message.
5.2.7. CONFIGURATION mode (only for authorised qualified personnel)
In configuration mode, you can set the functions of the radio drives and receivers. The
functions that can be set depend on the type of drive/receiver. You can find more detailed
information on configuration mode in the document “Configuring radio drives and receivers”,
which is available to download www.selve.de
