44
4.5.2. Semi-automatic setup mode WITHOUT relief
in operation: bottom position, top stop
When the movement is interrupted twice during operation, the system signalises that it is in
semi-automatic setup mode. The drive only finds the upper end position automatically.
Important: A limit stop is required for the upper end position (e.g. box awning)!
The lower end position must be approached first. After pressing the E button on the setting
switch for 3 seconds, move from here to the upper stop without interruption until the drive
automatically switches off.
Operation with
setting switch
Movement
E
1 s
Press and hold the E button of the setting switch for 1 seconds.
Both previously set end positions are deleted.
Note: Can be omitted during the initial installation or after
resetting to the factory settings.
E
STOP
STOP
Move the drive downwards to the required lower end position
using the UP or DOWN button.
E
3 s
Press the E button on the setting switch for 3 seconds
(= deactivate the relief in the upper end position).
STOP
STOP
From here, move to the upper stop without interruption. The
drive stops automatically. This correctly sets the direction of
rotation. Perform a test run. The drive moves upwards against
the stop and is no longer relieved.
Setting the end positions
