50
commeo commissioning/setting by radio
Note for settings under point 5.2.: The drive must be selected for these settings with a
transmitter in SELECT mode (status LED slowly flashes orange). After the setting has been
configured, the drive is still selected (see point 5.).
5.2.2. Semi-automatic setup mode WITHOUT relief
in operation: bottom position, top stop
When the movement is interrupted twice during operation, the system signalises that it is in
semi-automatic setup mode. The drive only finds the upper end position automatically.
Important: A limit stop is required for the upper end position!
The lower end position must be approached first.
Operation
Movement
9 s
Press the STOP button on the transmitter for 9 seconds.
Both previously set end positions are deleted.
Note: Can be omitted during the initial installation or
after resetting to the factory settings.
or
STOP
Move the drive to the lower end point using the UP or
DOWN button.
3 s
Deactivation of the relief: Press and hold the STOP but-
ton for 3 seconds. The direction of rotation will be set
correctly after the end positions have been set.
or
STOP
5 cm
From here, move to the upper stop without interrup-
tion. The drive stops automatically.
This correctly sets the direction of rotation. Perform a
test run. The drive moves upwards against the stop and
is no longer relieved.
