24
3.
2.
1.
4 . 3 F i t t i n g t h e l i n e d r u m a n d l i n e g u i d e –
2 0 0 S & 3 0 0 S
The line drum consists of two halves. It is easier to fit after the Furlex stay is fitted to the mast.
Feed the furling line through the hole in the line
guide fitting and then through the hole in the
line drum half which has a clip fitted.
Undo the clip andinsert the line into the
oval space as shown in the diagram. Fas-
ten the clip securely, but do not over-
tighten.
Fig: 4.3.a
Fig: 4.3.b
Fig: 4.3.c
Cont.on page 26.
Fasten the line guide fitting in the line guard
and bring this up into the assembly position.
Tighten the screws in the stainless steel
housing.
Slide the line guard on in the direction of the
clevis pin. Press the locking block in from
underneath (Arrow 2) on the opposite side so
that it “clips” firmly into place.
Fig: 4.3.d
2
4.
5.
2
2
1
2
1
Press the line drum halves together around the
lower bearing assembly. Each flange must align
with the cut-out in the lower bearing assembly.
Check that both connector clips engage.
