17
4 . 2 A s s e m b l y o f t h e l u ff e x t r u s i o n
2 0 0 S & 3 0 0 S :
Assembly should be carried out on a horizontal surface.
1. Unscrew the eye part of the upper terminal. Wind tape around the exposed thread of the male part to
protect it.
2. Each extrusion must be pushed on over the short joining sleeves from the upper end of the stay in
turn. Push the short joining sleeves up towards the upper end terminal and secure them in position
temporarily with tape around the stay.
Push the 1000 mm (39 3/8”) luff extrusion over all the short joining sleeves and partly over the
long, lowest joining sleeve.
Fit the long connecting plate at the same time as the sail feeder as shown in the diagram. Push the
joining sleeve up so that it is flush with the top edge of the sail feeder.
Connect the 2400 mm (94 1/2”) extrusion to the 1000 mm (39 3/8”) extrusion. Push the long join-
ing sleeve of the 1000 mm (39 3/8”) extrusion into the 2400 mm (94 1/2”) extrusion until it lies
flush with the lower edge of the 1000 mm (39 3/8”) extrusion.
Fig: 4.2.a
Fig: 4.2.b
Fig: 4.2.c
3.
4.
5.