21
14.2
Furlex rigging screw:
No spacer bush.
14.1
200 S & 300 S
Terminal part:
Press spacer bush over wire.
Screw out the socket on the lower terminal part and remove the wedge and former. These three
parts are no longer required. Put 2–3 drops of locking adhesive on the thread and screw the termi-
nal together. Check that the rod head sits correctly in the seat and that the seat is in the socket cor-
rectly. Tighten it securely. This is now permanently locked.
12. Fit the eye part of the upper end terminal permanently with locking ad any stop
screw/locking pin supplied.
13. Check the stay length FL in
”Calculation Table 1”
(3.5.1) & Fig. 3.5.a. If a Furlex rigging screw
is fitted, this should be extended 50%. See table 14.1.1 for Furlex rigging screw adjustment.
Fig: 4.2.i
11.
Fig: 4.2.j
Fig: 4.2 k
Guide the lower bearing assembly on from below. Push it carefully onto the extrusion so that the
stainless steel inner tube does not scratch the extrusion. Use cloth or paper for protection.
Fig: 4.2.h
10.
