25
Fasten the line guide fitting to the line guard
casing using the screws enclosed.
Start by first fitting the line drum half with the line
onto the lower bearing assembly. Tighten the screws
securely, thus locking the furling line. Check that
the end of the line is visible through the inspection
hole; if not, separate the line drum halves and put
the line in position as shown in Fig. 4.3.b.
4 . 3 F i t t i n g t h e l i n e d r u m a n d l i n e g u i d e –
4 0 0 S & 5 0 0 S
The line drum consists of two halves. These are easier to fit after the Furlex is fitted to the boat.
Feed the furling line through the hole in the line
guide fitting and then through the hole in one
of the line drum halves.
Bend the end of the line down so that it
covers the inspection hole in the line
drum half.
Fig: 4.3.a
Fig: 4.3.b
Fig: 4.3.c
Fig: 4.3.i
Slide the line guard on in the direction of the
clevis pin.
Fig: 4.3.d
4.2
1
4.1
1
1
1.
2.
3.
