22
17.2.
Only 400 S wire Ø12 only with Furlex rigging screw
Ensure that the flat faces of the rigging screw
are aligned. The rigging screw has an integral
stop to prevent it from being completely
unscrewed. Never try to adjust the rigging screw
past this point. Guide the adapter tube onto the
rigging screw and then guide the lower bearing assembly
down over this. The flat internal surface of the adapter tube matches
the rigging screw and its flat external surface matches the flat inner surface
of the lower bearing assembly, so that the components lock when assembled.
Terminal part:
Guide the lower bearing assembly down over
the terminal part. The inside of the lower bear-
ing assembly matches the flat face on the ter-
minal part.
Furlex rigging screw 400 S and 500 S
:
Ensure that the flat surfaces of all three components are aligned. The rigging screw has an integral
end stop to prevent it from being completely unscrewed. Never try to adjust the rigging screw past
this point. Guide the lower bearing assembly down over the Furlex rigging screw. As the inside of
the lower bearing assembly matches the flat faces, it will securely lock the rigging screw.
Fig: 4.2.o
Fig: 4.2.n
16.
400 S & 500 S
17.1
Fig: 4.2.m
Furlex rigging screw:
If a Furlex rigging screw is used, the flat faces of all three
parts must be aligned. As the inside of the lower bearing
assembly matches the flat faces, it will lock the rigging screw
when assembled. When fitting the Furlex, the rigging screw
should be unscrewed half-way.
15.2
Terminal part:
Guide the lower bearing assembly down over
the spacer bush and terminal part. The inside
of the lower bearing assembly matches the
flat face on the terminal part.
Fig: 4.2.l
15.1