Sekonic SR-3500, Operating Manual

Page: 43 / 130

- 42 -
■ Setting density balance
You can set the density balance level when using the SR-600/SR-9000 operating mode.
Density balance can be set so that when marks are read, marks lighter than the set density
balance will be ignored, and marks darker than the set density balance will be detected.
Density balance can be set from 1 to 15.
1.
Press the
MENU
switch to enter the menu mode.
2.
Use the
UP
and
DOWN
switches to select the following parameters,
and press the
FEED/ENTER
switch.
3.
Use the
UP
and
DOWN
switches to select [Density Balance] setting,
and press the
FEED/ENTER
switch.
(“ * ” mark fl ashes in the fi rst column of the fi rst line on the LCD.)
4.
Use the
UP
and
DOWN
switches to set the value.
5.
Press the
FEED/ENTER
switch to save the setting value into memory.
(The fl ashing “ * ” mark disappears from the LCD.)
6.
Keep pressing the
CLEAR/EXIT
switch until it returns to normal mode,
or press the
MENU
switch to return to normal mode.
Note)
See the operating manual of each type in regard to density balance.
Density balance
setting values
1 - 15
Data reading settings
■
Setting density balance
SR-3565(E).indd 42 SR-3565(E).indd 42 2007-8-16 10:19:35 2007-8-16 10:19:35