SEELEY INTERNATIONAL - INSTALLATION MANUAL
|
5
SPECIFICATIONS
SPECIFICATIONS
cont.
ELECTRICAL
It is a requirement of Seeley International that the electrical
power supply to all coolers is not mixed with other machines or
electrical circuits. Electrical installation must comply with local
laws and regulations.
Each cooler requires a minimum10 amp power supply.
Disconnection from the mains supply may be achieved by
having the plug accessible or by incorporating a switch in the
fixed wiring in accordance with the local wiring rules.
Specification:
115V, 230V / 50Hz, 60 Hz Single Phase (see nameplate for
exact data for this air cooler.)
The electronics module is fitted with a 12 amp manual reset
circuit breaker. To reset the circuit breaker turn off the isolation
switch, remove the Electronics Module and push the manual
reset toggle switch located underneath the Electronics Module.
The isolation switch on the module cannot be turned on without
the securing screw being in place.
If at any time the electrical supply cable is damaged, it must
be replaced by a special cord or assembly available from the
manufacturer or its service agent in order to avoid a hazard.
WATER
Specification:
Water Connections : 1/2 inch BSP
Minimum Pressure: 100kPa (15 PSI)
Maximum pressure: 800 kPa (115 PSI)
IMPORTANT!
If the water pressure exceeds 800kPa, then a
pressure reducing valve must be fitted near to the air cooler by
the installer.
The air cooler will function best when clean water is supplied.
Water that contains dissolved salts and other impurities will
cause the cooling pads to become blocked more quickly and
then they require maintenance. The water management devices
fitted will help to control the effects of poor quality water, BUT
THEY CANNOT ELIMINATE THE PROBLEM.
