Secure Care KinderGUARD ID, Installation Manual, Page: 56 / 96

Doc. No.: A05280692 Rev. AE ECO: 13200 Date: 11/04/2019
56
Latching Fire Alarm
Fire Alarm Factory Default Disabled
To e
nable the Latching Fire Alarm
1. Enter * 567*9876543216 #999

Four confirmation beeps = change accepted

One confirmation beep = change not accepted
To d
isable the Latching Fire Alarm
1. Enter * 567*9876543216 #909

Five confirmation beeps = change accepted

One confirmation beep = change not accepted
Locking of Life Safety 101 Features
This feature will lock the delayed egress and fire alarm settings. This feature is NON REVERSIBLE and cannot be
undone by initializing the panel. Make sure the Life Safety 101 features are correct and meet your local authorities’
requirements before locking the feature. To undo this feature the panel will have to be sent back to Secure Care Products,
Inc. to be reprogrammed at the standard repair fee.
1. Enter *309*9876543219
Software Version
To verify the software version:
1. Enter * 567 * 2 and hold
2. Count each series of beeps. The 4 series of beeps will represent the 4 digit software version number.
Example : 2 beeps pause, 5 beeps pause, 10 beeps pause, 10 beeps indicates version 2.500.
Elevator Mode
In default operation, the AUX relay will operate normally, the NO relay will CLOSE and the NC relay will OPEN during
alarms. The relays will also remain in there defaults states if the ID Exit Panel loses all power. When the Elevator Mode
feature is enabled, the AUX relays will operate normally but if the ID Exit Panel loses power, the AUX relays will change
state. This feature only affects the AUX relays when the power is powered down.
Elevator Mode Factory Default Disabled
To enable the elevator mode
1. Enter * 567 *0 hold the 0 until 1 beep is heard
To disable the elevator mode
1. Enter *567 *0 hold the zero until 2 beeps are heard
When the elevator mode feature is enabled the AUX relays will change to the alarm state when the panel loses power.
(Relays will change state).
SECTION 10 PROGRAMMING INSTRUCTIONS