Secure Care KinderGUARD ID, Installation Manual, Page: 24 / 96

Doc. No.: A05280692 Rev. AE ECO: 13200 Date: 11/04/2019
24
Flush Mount Enclosure (XIU, Door Guardian and KinderGuard Exit Panels)
The flush mount enclosure is designed to be mounted in the wall adjacent to the exit being monitored. It mounts using
the screws, washers, retainers, and strain relief provided with the enclosure. Wiring may be routed through one or more
of the four provided knockout locations on the back, sides, or top of the enclosure. The center of the enclosure should be
mounted 48” above the floor in accordance with ADA requirements.
Figure 9-4 Flush Mount Enclosure
After routing wires to the enclosure location, use the enclosure as a template to mark and cut the wallboard for inserting
the enclosure. Apply strain relief connector to required knockout locations. Route wires through strain relief connector.
Tighten strain relief connector around the wires. Wires should withstand a pull of 35 pounds without slipping through
the connector. Insert the enclosure into the wall.
Use the screws, washers, and retainer clips provided to mount enclosure securely in the wall. Review the diagram above
for assembly of the retainer clip. Insert retainer clip assembly into the slots located on the top and bottom of the enclosure.
Keeping pressure on enclosure inside the wall, tighten screws of the retainer clip assembly in forward most position until
enclosure is secure.
NOTE: Strain relief of routed cables is required to retain UL product
listing. If above instructions are not followed, the product UL listing is
subject to removal.
SECTION 9 INSTALLATION AND CONNECTIONS
retainer
clip
assembly