ENFORCER SLI 820R/-4
Tech Manual
Page 9
+12VDC
Factory horn
button
Ø
(-)
Alarm BROWN/WHITE wire
(honking horn output, tr.
ground, 200mA max.)
Factory
horn
Factory
horn
relay
Fig. 9 (-) Honking factory horns
NOTE If there is no factory horn relay, or if it draws
more than 200mA, a separate optional 30A relay must
be used with the BROWN/WHITE wire.
Fig. 10 2nd channel output
Alarm BLACK/WHITE wire
(2nd channel output, tr.
ground, 200mA max.)
Ø
To optional accessory
(positive switched)
Ø
+12V
Negative-triggered domelights:
GRAY/BLACK wire
Ø
+12V
BLUE wire (on connector 2)
+12V
Door switch
Domelight
Ø
Positive-triggered domelights:
GRAY/BLACK wire
Ø
PURPLE wire (on connector 2)
+12V
Domelight
+12V
Door switch
Ø
Fig. 11 Connecting to the
domelights (positive or negative)
A. Output Disarms alarm and supplies a
200mA transistor ground output as long as
a valid signal is received if the transmitter
button is pressed for 2 secs. For safety, 2nd
channel output operates only:
(1) If the ignition switch is OFF; or
(2) If a car door is open while the
ignition switch is ON.
B. Connection Connect the BLACK/WHITE
WIRE to a 30A relay to control trunk release
or other accessory. NEVER CONNECT THE
BLACK/WHITE WIRE DIRECTLY TO AN
OPTIONAL ACCESSORY, AS THIS WILL
BURN OUT THE 2ND CHANNEL OUTPUT,
AND POSSIBLY THE ENTIRE ALARM BRAIN.
Connector 3 (6-pin connector)
GRAY/BLACK WIRE (domelights), fig. 11
A. Output Supplies a 200mA transistor
ground output in one of three situations:
(1) When the alarm is disarmed, this wire
turns the domelights on for 30 seconds,
or until the ignition key is turned ON.
(2) When the alarm is triggered, this wire
flashes the domelights.
(3) When the ignition-controlled domelight is
enabled, turning OFF the ignition will
turn ON the domelight for 30 seconds.
B. Connection Connect the GRAY/BLACK
WIRE via a 30A relay to the domelights.
Never connect the gray/black wire directly to
the domelights, as this will burn out the
domelight output, and possibly the entire
alarm brain.
Fig. 8 Connecting to trunk & hood
pin switches
×
Alarm BLUE/WHITE wire (neg.
hood/trunk trigger input)
Trunk pin switch
Hood pin switch
+12VDC
Trunk light
×
Alarm BLUE/WHITE wire (neg.
hood/trunk trigger input)
Hood pin switch
Diode
1N4001
Hood/trunk
switch
Fig. 7 Connecting to the
trunk light & hood pin switch
Domelight
×
Alarm PURPLE wire (pos. door trigger input)
+12VDC
Fig. 6 Connecting to the
positive door triggers
Door switch
