30
SI1000 Operator Guide (SV62138 Rev. A)
All SI1000
models have a Manual Feeder M that allows you to feed
stapled sets of
up to three sheets,
one set at a time, for processing
by the machine.
Using the manual feeder
automatically turns off both sheet feeders
.
You can, however, use the manual feeder along with the envelope,
insert, fold-only and sealer selections to run a variety of jobs
manually.
To use the manual feeder, set up the machine as you normally would
for the job you’re running. The selections shown by the indicators for
Sheet Feeders A1 and/or A2 will be
ignored
by the machine. All other
selections apply to the manual job.
Feed stapled sets into the manual
feeder in the normal orientation for
sheets fed into the SI1000; that is,
face down
and
bottom edge
fi rst.
Take one stapled set and feed it
gently into the manual feed slot until
the machine automatically starts
and draws the set from you. The
machine processes the set and
ejects it into the stacker in the usual
manner.
NOTES:
•
Be sure to feed the set in squarely. If you feed it in at an angle, a
poor fold or jam could result.
•
Feed the set into the machine gently. Very little force is needed.
•
The fi rst set will
not
seal even if you set up the system to do so.
This “trial” feature allows you to inspect the processed job to
make sure that all pieces were inserted correctly and that the
address appears in the envelope window.
The Manual Feeder M
CAUTION!
Feeding more than three sheets in a set may
damage your machine.
Feed sets
face down,
bottom edge fi rst
Manual Feed
