14
SI1000 Operator Guide (SV62138 Rev. A)
Insert Feeder C
is only available on certain machine confi gurations.
Use this feeder to add additional inserts to your envelope that
do
not
require folding by the machine. Feeder C is especially suited
to feeding pre-folded or thicker inserts such as business reply
envelopes (BREs), response cards and similar materials.
Always fan (aerate) inserts before
you load them. This prevents them
from sticking together.
Then tap the stack of inserts onto a
fi rm surface to align the edges.
Place the insert stack into
Feeder C.
IMPORTANT:
The orientation of
the insert stack depends on the
nature of the material being run.
For pre-folded inserts, it’s normally
best to load with the “closed” edge
feeding fi rst. You can usually load
business reply envelopes right way
up and facing you. However, if the
fl aps are pulled open when feeding,
try loading the envelopes with the
fl aps down and facing you.
Slide the two side guides up to
the insert stack then
slightly
back
them off. Use the blue handles
at the rear of the guides when
moving them.
IMPORTANT:
The setting is
correct when the guides control
the inserts but in no way restrict
their feed into the machine or
cause them to feed at an angle
(skew). If the guides are too tight,
inserts may not feed reliably; if
they are too loose, inserts may
skew as they feed into the machine.
Loading
Loading the Insert Feeder (Feeder C)
