40
SI1000 Operator Guide (SV62138 Rev. A)
Reference
First, remove all paper from the
affected feeders as indicated on the
display. Then, if necessary, clear
sheets
… from sheet feeders/manual
feeder
If the display indicates a jam in the
sheet feeder(s) or manual feeder
areas, pull the feeder assembly
from the machine as shown.
Then carefully remove any stalled
material from the machine.
… from area beneath cover D
If the display indicates a jam
beneath cover D, press the blue
button marked
D
to release the
cover. Lift the cover using the fi nger
grips on each side of the stacker.
Then carefully remove any stalled
material from the machine.
When closing the cover, latch it
closed by pressing down on the fi nger grips or the central part of the
cover in front of the envelope feeder. DO NOT press down on the
stacker.
Inserts or business reply envelopes feed poorly from Insert
Feeder
Changing the orientation of the insert stack may help. For pre-folded
inserts it’s normally best to load with the closed edge feeding fi rst.
Business reply envelopes can normally be loaded right way up and
facing you. However, if the fl aps are pulled open when feeding, try
loading with the fl aps down and facing you.
Following installation of Sheet Feeder 2, the system doesn’t
work
•
Check that the SI1000 is correctly located onto Sheet Feeder 2.
•
Turn the machine off, wait a few seconds and then turn it back
on.
•
Check that no debris (dust, paper, etc.) has fallen into the Sheet
Feeder 2 electrical connector.
Clearing Material Jams
Continues on next page...
Button D
