Seat Toledo 2019, Owner'S Manual, Page: 220 / 300

Driving
On releasing rocker switch
2
from

, the
current speed is stored and will remain con-
stant without having to press the accelerator
pedal.
Increasing speed by pressing the acceler-
ator pedal
●
Press the accelerator to increase the speed
of the vehicle.
●
Release the accelerator and the previously
programmed speed will be resumed.
If, when pressing the accelerator, the vehicle
exceeds the programmed speed by more
than 10 km/h (6 mph) for more than 3 mi-
nutes, the set speed will be deleted. The
speed will have to be stored again.
Increasing speed by pressing switch
2
●
Press rocker switch
2
›››
Fig. 222
›››
page 217 in position

.
●
If the button is held down in the

position,
the speed increases continuously. Release
the switch when the required speed is
reached. The speed is stored.
Setting a lower speed
●
The set speed can be reduced by pressing
switch
2
›››
Fig. 222
›››
page 217 in

.
●
If the button is held down in the

position,
the speed decreases continuously. Release
the switch when the required speed is
reached. The speed is stored.
●
On releasing the switch at speeds of less
than 30 km/h (19 mph), no speed will be set
and the memory will be deleted. The vehicle
must be moving at a speed of over 30 km/h
(19 mph) and switch
2
pressed again to

for it to be set.
The speed can be reduced by pressing the
brake pedal, which temporarily switches off
the cruise control.
Temporary deactivation of cruise control
Cruise control is switched off temporarily
by pressing switch
1
›››
Fig. 222
›››
page 217 in

or by pressing the brake
or clutch pedal.
The set speed is stored.
To recover the set speed, briefly press the
button
2
in

position once you have re-
leased the brake pedal.
Turning off the cruise control system
●
Move knob
1
›››
Fig. 222
›››
page 217 to
the

position.
WARNING
●
For safety reasons the cruise control sys-
tem must not be used in dense traffic or
where roads conditions are poor (e.g. due
to ice, aquaplaning, loose grit, snow) - Risk
of accident!
● The programmed speed can only be re-
established if it is not too high for current
traffic conditions.
●
Always switch the cruise control system
off after using it in order to avoid involunta-
ry use.
CAUTION
●
The cruise control cannot maintain a
constant speed when the vehicle is moving
downhill. The vehicle tends to accelerate
under its own weight. Therefore, shift down
or use the brake pedal in good time to slow
the vehicle.
Note
●
In vehicles with an automatic gearbox,
the cruise control system cannot be
switched on if the selector lever is in posi-
tion P, N or R.
●
In vehicles with a manual gearbox, the
cruise control cannot be switched on if first
gear or reverse gear is engaged.
218