Seat Toledo 2019, Owner'S Manual, Page: 117 / 300

Opening and closing
Automatically disabling sensors
If the vehicle is not locked or unlocked for a
long period of time, the proximity sensor on
the passenger door is automatically disa-
bled.
If one of the sensor surfaces on the door han-
dles is often activated in an unusual manner
with the vehicle locked (e.g. by the branches
of a bush rubbing against it), all proximity
sensors are disabled for a time. If this only
happens with the exterior sensor on the driv-
er's door, only this sensor is disabled.
Sensors will again be enabled:
●
After a time.
●
OR: if the vehicle is unlocked with the but-
ton

on the key.
●
OR: if the boot is opened.
Keyless Access temporary disconnection
function*
You can deactivate the vehicle's Keyless Ac-
cess unlocking for a locking and unlocking
cycle.
●
Move the gear lever to position P (if the ve-
hicle has automatic gearbox), since other-
wise the vehicle cannot be locked.
●
Close the door.
●
Push the central locking button

on the re-
mote control and touch the locking sensor
surface
›››
Fig. 124
B
on the driver door han-
dle once within the following 5 seconds. Do
not grab the handle or the vehicle will not
lock. Deactivation is also possible if the vehi-
cle is locked through the driver’s door lock.
●
To check that the function has been deacti-
vated, wait at least 10 seconds, grip and pull
on the door handle. The door should not
open.
The next time the door can only be unlocked
via the remote control or the lock cylinder.
The next time the door is locked/unlocked,
Keyless Access will be active again.
Convenience functions
To close all electric windows, the sliding roof
and electric tilting panoramic roof
with the
convenience feature , keep your finger on
the lock sensor surface
B
located on the ex-
terior part of the driver or passenger door
handle for a few seconds until the windows
and roof close.
The doors opened by touching the sensor
surface of the door handle depend on the
settings that have been activated in the Easy
Connect system with the

button and the
SETTINGS
and
Opening and closing
function
buttons.
CAUTION
The sensor surfaces on the door handles
could engage if hit with a water jet or high
pressure steam if there is a valid vehicle
key in the proximity. If at least one of the
windows is open and the sensor surface
B
on one of the handles is activated continu-
ously, all windows will close. If the water jet
or steam is briefly moved away from the
sensor surface
A
on one of the handles
and then pointed at it again, all the win-
dows will probably open
›››
page 115, Con-
venience functions .
Note
●
If the vehicle battery has little or no
charge, or the vehicle key battery is almost
or entirely out of charge, you will probably
not be able to lock or unlock the vehicle
with the Keyless Access system. The vehi-
cle can be unlocked or locked manually
›››

page 11 .
●
If there is no valid key inside the vehicle
or the system fails to detect one, a warning
will display on the dash panel screen. This
could happen if any other radio frequency
signal interferes with the key signal (e.g.
from a mobile device accessory) or if the
key is covered by another object (e.g. an
aluminium case).
●
If the sensors are very dirty, e.g. have a
layer of salt, the correct functioning of the
sensors on the door handles may be affec-
ted. If this is the case, wash the vehicle
›››
page 265 .
● If the vehicle is equipped with an auto-
matic gearbox, it may only be locked in the
gear stick is in position P.
»
115