Page 13
VS8197.V2 Issue: 1 - 23/11/11
Original Language Version
This helps prevent the tool from slipping from your hands and allows proper
ventilation.
Inspect if the warning label on charger’s surface is intact and readable.
Select appropriate location for charger before using. Check work area for:
The charger must be between 41°F (5°C) and 113°F (45°C) for charging.
•
Inspect that the plug fits correctly into the desired outlet.
•
The charger needs a clearance of at least 4” (10cm) on all sides to
•
maintain a proper operating temperature.
4.4 Battery Charging Procedures
1
NOTE: New battery reaches full capacity after approximately 5 charging and
discharging cycles.
The tool has a 3.7V built-in lithium-ion rechargeable battery. When the battery is
low, a “
Battery critically low!
” message appears and suggests you to charge the
battery.
There are two means of charging battery:
1) To charge battery by charger: Locate the DC power port on the tool.
With dry hands, connect the tool to the mains charger to start
charging.
2) To charge battery by USB cable: Locate the USB port. With
dry hands, connect the tool to a PC with USB cable to start charging.
The battery will begin charging automatically. Whilst the battery is
•
charging, the charging indicator light will illuminate red.
When the battery is fully charged, the charging indicator light will
•
illuminate green and the charger will stop charging.
Once the battery is charged, it is ready to be used. There is no risk of
•
over-charging the battery.
Unplug charger from outlet once charging completes.
•
