57
© Sealevel Systems, Inc.
SeaI/O | SL9049 11/2021
Enter the username and password to access the web page (
Error! Reference source not found.
). The default u
sername and password are both “seaioadmin”.
It is highly recommended that you change the username and
password from the defaults.
Figure 4 - HTTP authentication window
Use the navigation bar (on a desktop PC) or dropdown menu (on a mobile device) to navigate to the Profiles
page. Add a profile for a
wireless access point using the green “+” button. Enter the name of the access point,
the security type, and the password (if applicable). Optionally, modify the profile priority. Restart the device by
momentarily pressing the reset button on the side or by cycling power.
On subsequent boots, the device will boot into Infrastructure Mode, indicated by the STAT LED blinking once. It
will automatically attempt to connect to the profile(s) in its list of access point profiles in order of priority.
Your SeaI/O device should now be visible on your network. You can now access the internal configuration page
in a similar manner as before to configure the device further as necessary.
To return to AP mode at any time after initial setup, remove power from the unit, press the configuration button
on the front of the device, and apply power until the STAT LED blinks twice. The device will enter AP mode for
the current boot only.
To reset all network and serial settings to their factory defaults, press and hold the configuration button for 10
seconds. The STAT LED will blink 5 times to confirm, and the device
