Section 2. Operating Procedures
16
5. Cleaning the Laminator
1. It is important to clean the machine
immediately
after the end of the material is
completely through the Dryer panel.
2. Switch the machine into Stop mode.
3. Using a
WET
cloth wipe the 2 draw down bars to remove any excess sealant
from them.
4. Wipe the stainless steel table directly behind the Draw Down Assembly if it has
any sealant on it.
Note:
Sometimes the tail end of the material will drag a little coating onto the
stainless steel table behind the Draw Down Assembly. It needs to be
cleaned off quickly because the heat from the Dryer Panel will dry it
rapidly.
5. Dry the Draw Down bars with a clean dry cloth.
6. Use a small cup of water to dip the tip of the flex hose into in order to pull excess
coating out of the tube. Wipe the tip of the flex hose dry.
7. If you are finished with the machine for a period of time you should also wipe any
excess sealant out of the drain tank. (A large 4” X 6” sponge works well for this.)
Summary of Contents for AquaSEAL SW-5000
Page 22: ...Section 4 After Sales Support 21...
