40
Revision 2.EL950 1.3.1074C 18.6
EXACT CHANGE
Sets the coin tube value that will trigger the display to show Please Use Exact Change message. For
example, if Exact Change is set to $5.00, the message will display when the total of coins in the tube, as
counted by the VMC, is at or below $5.00 total.
ALTERNATE RULE
This function prevents a vend from occurring, flashes the Please Use Exact Change message and will return
the established credit amount if one or more of the coin tubes are too low to give back the correct change
for the vend. Note: This setting must be OFF if using a bill validator only. If using a bill validator only, prices
must be divisible by the denominations accepted by the bill validator.
UNCONDITIONAL ACCEPTANCE
Sets the unconditional acceptance value. All cash box coins or bills equal to or less than this set value
will be accepted, even if the changer cannot return an equal amount of change. When set to 0 (zero), all
changer tube coins are accepted. Bills are accepted once there is enough change in the changer to pay back
the bill type. Note: the Unconditional Acceptance set value is adjustable but the maximum value is equal to
the largest denomination of currency or coin accepted by the changer or validator.
STEP
DISPLAY
1.
Press Service Mode Button
Motor Count or Error Code **
2.
Press 6 for Password (Advanced Features) Menu
Password
3.
Enter Password (default 2314)
Advanced Features
4.
Press 2 for Exact Change
Exact Change $--.00 *-Exit 1 Edit
5.
Press 1 to edit Exact Change
Exact Change (Flashing) *-Exit 1-Edit
6.
Use number keys to enter an amount
Exact Change (New Setting) *-Exit 1-Edit
7.
Press # to save the setting
Exact Change (New Setting) *-Exit #-Save
8.
Press * two times to exit
0.00
STEP
DISPLAY
1.
Press Service Mode Button
Motor Count or Error Code **
2.
Press 6 for Password (Advanced Features) Menu
Password
3.
Enter Password (default 2314)
Advanced Features
4.
Press 2 for Exact Change
Exact Change $--.00 *-Exit 1-Edit
5.
Press 2 to set Alt Rules
Alt Rules (Current Setting) *-Exit 2-Edit
6.
Press 2 to toggle ON/OFF (default ON)
Alt Rules (Choice Flashing) *-Exit #-Save
7.
Press # to save the setting
Alt Rules (New Setting) *-Exit 3 Edit
8.
Press * two times to exit
0.00
STEP
DISPLAY
1.
Press Service Mode Button
Motor Count or Error Code **
2.
Press 6 for Password (Advanced Features) Menu
Password
3.
Enter Password (default 2314)
Advanced Features
4.
Press 3 for Unconditional Acceptance menu
Uncond Accept: (Current Setting) *-Exit #-Edit
5.
Press 3 then enter value
Uncond Accept: (New Setting) * Exit #-Save
6.
Press # to save the setting
Uncond Accept: (New Setting) *-Exit #-Save
7.
Press * two times to exit
0.00
