If it was submerged in
salt water
,
spray bilge and all components with
fresh water using a garden hose to
stop the salt corroding effect.
CAUTION:
Never try to crank or
start the engines. Water trapped
in intake manifolds would flow to-
wards the engines and may cause
severe damage to the engines.
Bring the boat to be serviced by an
authorized Sea-Doo Sport Boat dealer
as soon as possible.
CAUTION:
The longer the delay be-
fore you have the engine serviced,
the greater the damage will be to
the engines. Failure to have the en-
gines properly serviced
will
cause
severe engine damage.
Fuel-Flooded Engines
If an engine is fuel-flooded and does
not start, this special mode can be ac-
tivated to prevent fuel injection and ig-
nition while cranking. Proceed as fol-
lows to activate it.
– Stop the engine.
– Set throttle lever in idle position.
– Set shifter lever in neutral position.
– Install DESS key on DESS post.
– From engine compartment, manu-
ally rotate throttle lever into fully
opened position and HOLD.
F1
3
G02Y
1
TYPICAL
1. Fully-open position
– Ask someone to press the start/
stop switch to crank engine while
still HOLDING the throttle lever in
fully-opened position. The drowned
mode is now on.
– Crank engine several times.
CAUTION:
Do
not
hold
the
start/stop switch more than 30 sec-
onds. A rest period should be ob-
served between the cranking cycles
to let the starter cool down. Pay
attention not to discharge the bat-
tery.
– Release engine start/stop switch.
– Release throttle lever and start/
crank engine again to allow start-
ing.
NOTE:
Releasing throttle lever will
bring back to its normal mode.
If it does not work:
Disconnect ignition coil connectors.
All three ignition coils are located on
the cylinder head directly on the spark
plugs.
1
R1
5
0
3
motr1
75
A
1. Ignition coils
_____________________
99
Summary of Contents for 230 Challenger 2008
