Sea-doo 230 Challenger 2008, Operator'S Manual

Page: 132 / 160

lmo2007-002-008_a
1. Intercooler
2. Inlet hose clamp (reusable)
3. Outlet hose clamp (replace)
– Let the intercooler drain, then re-
connect the bottom hose.
– By using a funnel and a small hose,
pour approximately 200 mL (6.76 oz
U.S.) of antifreeze into the intercool-
er through the outlet nipple.
1
F19D0DA
2
3
TYPICAL
1. Intercooler
2. Outlet nipple
3. Inlet nipple
– Reconnect the intercooler top hose
and secure with a new clamp.
– Disconnect the manifold top water
outlet hose from the exhaust pipe.
F1 8 D0IB
1
3
2
1. Exhaust manifold
2. Exhaust pipe
3. Water outlet hose clamp (reusable)
– Install a funnel at the end of wa-
ter outlet hose, then pour approxi-
mately 300 mL (10.14 oz U.S.) of an-
tifreeze into the exhaust manifold.
– Reconnect the upper water out-
let hose and secure with existing
clamp.
CAUTION: It is highly recommend-
ed to pour antifreeze into the in-
tercooler and exhaust manifold.
Failure to do so, may cause severe
damage to these components.
CAUTION: Use only undiluted an-
tifreeze (100% concentration) . The
premixed antifreeze available from
BRP is NOT suitable for this partic-
ular application. Its concentration
will be reduced when mixed with
remaining water trapped in water
jackets.
NOTE: When available, it is recom-
mended to use biodegradable an-
tifreeze compatible with internal com-
bustion aluminum engines. This will
contribute to protect the environment.
NOTE: The engine will not have to run
during this operation but should have
been ran before, to exhaust as much
water as possible, from cooling sys-
tem components.
130
_____________________