Sea-doo 230 Challenger 2008, Operator'S Manual, Page: 59 / 160


WARNING
• BEFORE using the speed control
system or taking on passengers
and starting any watersport ac-
tivities:
– Thoroughly read and un-
derstand all the operating
instructions provided in the
PERFECT PASS INSTRUC-
TION MANUAL
.
– Make sure to have acquired
the appropriate experience
with your boat to be thor-
oughly familiar with its op-
eration and dynamic behav-
ior.
• The Perfect Pass is not a steer-
ing control device. You must
always be on the look-out and
maintain control of the boat at
all time using safe driving tech-
niques.
• Always keep your hand on the
throttle lever while the Perfect
Pass is in operation.
• The Perfect Pass is no substitute
for normal safe watersport prac-
tices. Never pull a skier, wake-
boarder, or any other water toy
without a spotter onboard.
• Do not modify the Perfect Pass
system in any way. If a malfunc-
tion is noticed or suspected, do
not use the system and have an
authorized dealer inspect or re-
pair it.
NOTE: BRP recommends includ-
ing the linkage test described in
the
TROUBLESHOOTING section
of the PERFECT PASS INSTRUC-
TION MANUAL as part of your normal
PRE-OPERATION CHECKS routine in-
spection.
13) Monitoring Gauges
F1 3 H0 5 Y
2
4 3
1
TYPICAL
1. Battery
2. Engine
3. Temperature
4. Oil
Low Battery Warning Light
Before the battery becomes too dis-
charged to start the engines, the volts
indicator light will come on.
When the indicator light is on, you
should discontinue all use of electrical
accessories immediately and start the
engine(s) in order to recharge the bat-
tery.
Check Engine Light
When the ECM detects a fault code,
the check engine light will come on
and a beep may sound.
Turn engine(s) off. Wait one (1)
minute. Restart engine(s). If light(s)
remains lit, take boat to nearest au-
thorized Sea-Doo Sport Boat dealer
for servicing.
Engine Temperature Light
CAUTION: If the temperature indi-
cator light comes on, stop engine(s)
as soon as possible.
Turn off engine as soon as possible.
Check oil level(s) and refill.
Check coolant levels. Refer to LIQ-
UIDS . If engine(s) still overheats, con-
tinue the following procedure.
Perform JET PUMP WATER INTAKE
AND IMPELLER CLEANING proce-
dure described in SPECIAL PROCE-
DURES .
_____________________
57