62
26. Make sure there is sufficient space to lower the walking deck.
Keep a minimum clearance behind the machine of 79” (2 m) and
24” (0.6 m) on each side. This is the recommended safe distance
for access, movement and emergency dismounts from the
machine.
27. Make sure there is no object on or around the treadmill to spill or cause
blockage from the fully unfolded position.
28. Slightly push the walking deck forward toward the console. With your
foot lightly push the top part of the hydraulic lift forward until the locking tube
releases and you can pull the walking deck away from the console. Hold up
the rear of the walking deck, and move to the side of the machine.
Keep clear of the movement path of the walking deck.
29. The hydraulic lift is set up to drop gradually. Hold onto the walking deck
until approximately 2/3 of the movement down. Lower the weight with your
legs. Be aware that the walking deck can possibly drop quickly in the last part
of the movement.
If you used spray lubricant, wait 5 minutes before turning on
power to the machine to allow the aerosol to dissipate.
30. Attach the power cord and turn on the Treadmill by flipping the power
switch to ON.
31. Start the belt at the slowest speed and stand well behind the machine.
Let the belt operate for approximately 15 seconds. Notice if the Walking Belt
needs to be adjusted so it runs centered on the machine.
Be sure not to touch the walking belt or step on the power cord.
Keep bystanders, children and pets away from the machine you
are servicing at all times.
32. If the Walking Belt needs to be adjusted, use a 6mm hex wrench on the
side the belt should move away from and rotate the Adjustment Bolt a 1/4
turn clock-wise.
33. Allow the Walking Belt to adjust to the new tension by allowing it to run a
couple seconds.
34. Repeat steps 44 and 45 until the Walking Belt is centered.
35. Switch off your machine.
36. Take care to clean up any excess lubricant from the deck.
Adjustment Bolt
Adjustment Bolt
