Schwarz SB10B, Operating Instructions Manual, Page: 43 / 96

7.2 Transverse cleaning 43
7.2 Transverse cleaning
Table 7.2 Transverse cleaning - measures at faults
No transverse cleaning
Error Cause Remedies
No power - motor protection tripped - check cause (E)
- control defective - check (E)
- connections - check (E)
- brush motor defective - check (E)
Drive - carriage bearing defective - repair
- motor defective - check motor (E)
- drive chain defective - check, repair
- tappet screws defective - replace
- control defective - check (E)
- connections - check (E)
- frequency converter - check (E)
- PLC - check (Schwarz GmbH)
Transverse
cleaning
sensors - defective - replace and readjust
- incorrect setting
- see "Setting up the transverse clean-
ing sensors"
Brush
- retention nut loose - tighten
- tappet piece on shaft is miss-
ing
- check, insert if required
Transverse cleaning too strong or too weak
Error Cause Remedies
Transverse
cleaning
sensors
- sensor misadjusted
- see "Setting up the transverse clean-
ing sensors"
- defective - check (E)
- PLC - check (Schwarz GmbH)
- supply via screen - correct
Drive - PLC - check (Schwarz GmbH)
- roller carriage bearing - check, replace if required
- frequency converter - check (E)
Brush - worn - replace