Schwarz SB10B, Operating Instructions Manual, Page: 18 / 96

18 4 Technical information
4.4 Deduster setup and commissioning
Type of deduster: PF-Jet 9000

Set up the deduster with a crane at the transport eyelets intended for this.

The included sealing tape must be glued on between the muffler hood and deduster.

Put the muffler hood on the deduster with the scripture Fa. Richters to the front.

Fasten the hood to the deduster with the lateral closures.

Create electrical connections

Open the fan chamber door and check deduster motor rotating direction. (see arrow at
the motor).

Properly connect pipelines to cleaning machine and seal.
4.5 Machine disassembly

Disconnect the cleaning machine from the circuit and clean.

Disassemble the roller tables at the inlet and outlet sides and put them aside.

Disconnect deduster from the machine.

Remove floor fastenings.
4.6 Electrical connections
The electrical supply is created by a fixed connection. The supply is to be protected according to
the Technical data (see page
16 ) and the circuit diagram (see page 86 ).
The electrical supply line is produced by connecting the supply cable in the control cabinet. Ob-
serve the right-ward turning field. The supply is to be protected according to the technical data
(see chapter
4.1 Technical data , page 16 ) and the circuit diagram (see chapter 8.10 , page 86 ).
The place of setup of the deduster must be selected to
warrant proper stance on firm underground.
When setting up, observe the extraction connection.