Schwarz SB10B, Operating Instructions Manual, Page: 24 / 96

24 5 Operation
Abbildung 5.4 Einstellung Belagreinigung Figure 5.13 Manual operation pages 301, 302
Figure 5.13
5.5 Setting up the transverse cleaning sensors
The following setting work must only be performed with a new brush.

Bring the machine to a standstill.

Set both wear amounts of the sensor to be adjusted to zero in the menu "400 Target
values" (see Figure
5.6 , page 25 ).

Perform test run.

If the distance from the frame formwork is too large, the respective sensor "A" or "B"
must be pushed closer towards the other (see Figure
5.5 Adjust transverse-cleaning of
the sensors., page 24 ).

The front side is adjusted via sensor "A".

The rear side is adjusted via sensor "B".

The sensors can be adjusted by moving the holding angles "C" or "D".
Correct setting: Wear amount = 0 and brush slightly touches at the formwork.

Perform test run.

Repeat the adjustment until the correct setting has been reached.
The settings described above are performed ex works and may need to be repeated after a sensor
change.
Figure 5.5 Adjust transverse-cleaning of the sensors.
A
B
C
D