Schwarz SB10B, Operating Instructions Manual, Page: 23 / 96

5.4 Setting up the machine (height and width settings) 23
5.4 Setting up the machine (height and width settings)

Switch on the machine.

The system fully-automatically adjusts in weight and height to the frame formwork to be
cleaned.

Setting the pressure pre-tension of the width setting (see page 25 )

The height setting does not need to be adjusted, since fine setting of the cover cleaning
is performed from the outside. See below section cover cleaning.

Adjustment of all brushes is possible in operation.
Side cleaning

Moving and regulating of the side brushes is possible via the corresponding buttons at
the control cabinet.

Side brushes can be switched ON or OFF in pairs via the operating panel for automatic
mode (see Figure
5.13 ).
Cover cleaning

If required or if the disc brushes are worn, the respective disc brush may be adjusted
individually in height via the carriage "A" from the outside using the nut wrench (acces-
sories SW19) "B" (see Figure
5.3 Setting cover cleaning).

The disc brushes should have an incline of 3 to no more than 5 degrees. “C”. Thus, the
front edge of the brushes is higher than the rear edge and the formwork elements can
be transported more easily under the disc brushes.
Figure 5.3 Setting cover cleaning